960 Masonry Cleaner
AC-3 Cleaner
Muriatic Acid
Masonry Cleaner 700
H.D. 900Restoration Cleaner
Masonry Cleaners
Caulks and Sealants
Concrete Admixtures
Conproco Waterproofing
Curing Compounds
Construction Adhesives
Construction Sealers
Stucco
Epoxy Systems
Floors and Walls
Grout
Paints and Coatings
Roofing Materials
Thoro Waterproofing
Waterproofers
Water Repellents

AC-3 Acid Cleaner has a pleasant clean odor and dispels no harmful or corrosive fumes.

AC-3 three way cleaning action will penetrate deeply into the surface and will dissolve, dislodge and foam to the surface from easy removal of dirt, oil, grease and scum.

AC-3 Cleaner removes cement drippings and waste from new surfaces. It will also clean and renew old weathered and stained concrete and masonry buildings and prepare the surface to receive weather proof treatment or paint.

AC-3 will remove efflorescence, dirt and rust stains from concrete, ceramic tile, terrazzo, marble, slate, stone and porcelain bath fixtures.

AC-3 may also be used on metal surfaces to remove grease, dirt and oil. Cuts size coating and film. Brightens and cleans off oxidation. Etches and cleans concrete floors for painting.

CAUTION
Since AC-3 contains acid and other strong cleaning agents, it should be used with care. Protect eyes, skin and surrounding areas. User should make a test sample, allowing it to dry thoroughly to determine it's suitability for job conditions and requirements.

Usage Directions
From most surfaces and job conditions AC-3 should be diluted with 1 to 10 parts of water. Always use the mildest solution that can do the job. Tough stains and hardened mortar may require full strength.

First dampen surface with water. Apply AC-3 at proper strength to surface and agitate or scrub with nylon or other acid resistant brush for 2 or 3 minutes or until bubbling action stops. Rinse with clean water, agitate while rinsing. Do not do too large and area at one time, so that the loosened dirt may allowed to settle back or dry. Repeat cleaning operation on stubborn stains as required.

Allow all surfaces to dry before waxing, painting or sealing. Terrazzo must be waxed or sealed as soon as dry.

When clenaing walls start at the bottom and work upward.

One gallon cleans approximately 300 sq. ft., depending on porosity and job conditions.

Chargar Coporation
299 Welton Street
Hamden, CT 06571